Below are steps for configuring Windows 8 network settings to run your Ipico Reader with Lapio Connect.
This PC Folder → Open Control Panel → System and Security
Once in System and Security → Network and Internet
NETWORK AND INTERNET→ Network Sharing Center → Change Adapter Settings
Right Click and choose Properties
Choose Internet Protocol Version 4 (TCP/IPv4) → Properties
Choose: Use the following IP address:
First, find the IP address on your Ipico Reader. Next, enter the IP address but the last number must be lower than what is on the reader.
Ipico Reader: 192. 168. 1. 11
Computer IP Address: 192. 168.1.10
Enter the Subnet mask: 255 . 255. 255. 0
If you need additional help, contact Lapio support at [email protected]